1. Open the glue seal and unscrew the cap counterclockwise. The red dot on the cap will sink a little (do not pull the white cover out)
2.Squeeze the bottle to apply glue evenly on the surface of the adherend (the dispensing needle can be installed to control the amount of glue)
3. Immediately apply the adhesive and press for 30 seconds or more (if the temperature is low, please extend the positioning time). The ideal effect of the glue can be achieved after 24 hours.
4. Tighten the lid clockwise and wipe the mouth with a paper after using.
1. The bonding surface must be clean and free of any contaminants such as dirt, grease, grease, and rust.
2. When removing the product from the refrigerated environment, allow the adhesive to reach room temperature before use.
3. Keep away from children and use it in a ventilated place.
4. Do not wear gloves when handling. If you want to wear gloves, please choose rubber gloves. If the glue accidentally touches the skin, please do not wipe it with a paper towel. Please rinse immediately with soapy water.
1. Rub the stick material on both sides with a sand film paper and clean up the dust, Then brush glue to the surface (slits can be used with needles).
2. Open the slit with the insert and drying for 15 minutes under room temperature. Then use a hair dryer to heat the opening for about 20 seconds.
3. One-time alignment, do not move back and forth, press hard for 30 seconds, and finally tied with rubber bands for 24 hours.